Table of Contents
Advertisement
Removing the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
remove the front
3. Using the management software, prepare the drive for removal.
If the drive is online, the green activity or fault indicator blinks while the drive is powering off. When the drive indicators are
off, the drive is ready for removal. For more information, see the Storage controller
storagecontrollermanuals
CAUTION:
Before attempting to remove or install a drive while the system is running, see the documentation
for the storage controller card to ensure that the host adapter is configured correctly to support drive
removal and insertion.
CAUTION:
To prevent data loss, ensure that your operating system supports drive installation. See the
documentation supplied with your operating system.
Steps
1. Press the release button to open the drive carrier release handle.
2. Holding the drive carrier release handle, slide the drive carrier out of the drive slot.
Figure 49. Removing a drive carrier
Next steps
Replace the drive carrier
Installing the drive carrier
Prerequisites
CAUTION:
Before removing or installing a drive while the system is running, see the documentation for the
storage controller card to ensure that the host adapter is configured correctly to support drive removal and
insertion.
CAUTION:
Combining SAS and SATA drives in the same RAID volume is not supported.
90
Installing and removing system components
Safety
bezel.
or
drive
blank.
instructions.
documentation.https://www.dell.com/
Advertisement
Table of Contents
