System Battery; Replacing The System Battery - Dell PowerEdge XR5610 Installation And Service Manual

Figure 109. Installing the M.2 SSD module
Next steps
1. If applicable, replace the BOSS
2. Follow the procedure listed in the

System battery

This is a service technician replaceable part only.

Replacing the system battery

Prerequisites
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to
the manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the BOSS N1
NOTE: The procedure to remove the system battery is the same for Rear Accessed and Front Accessed configurations.
Steps
1. To remove the battery:
a. Push the battery holder clip away from the battery.
CAUTION: To avoid damage to the battery holder clip, ensure that you do not bend the battery holder clip
while installing or removing a battery.
b. Pull the battery out of the battery holder.
136 Installing and removing system components
module.
After working inside your
Safety
Before working inside your
card.
system.
instructions.
system.