Table of Contents
Advertisement
Table 103. Configuration 1: R3 (continued)
Card type
Broadcom (NIC: 10G) (FH)
Broadcom (NIC: 1G) V2
Intel (NIC: 25G) (FH) 2P,S28
Intel (NIC: 10G) (FH) 4P,BT
Intel (NIC: 1G) V3
Intel (NIC: 1G) (FH) 2P,BT
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE:
The procedure to remove the expansion card risers is the same for Rear Accessed and Front Accessed
configurations.
Steps
For riser 3, first disconnect the cables from the system board. Using the Phillips 2 screwdriver, loosen the blue thumbscrew.
Holding the blue touch points, lift the expansion card riser from the riser connector on the system board.
Figure 97. Removing the expansion card riser 3
Next steps
Replace the expansion card
Slot Priority
1,2
1,2
1,2
1,2
1,2
1,2
Safety
instructions.
Before working inside your system
riser.
Maximum number of cards
2
2
2
2
2
2
.
Installing and removing system components
127
Advertisement
Table of Contents
