Table of Contents
Advertisement
Figure 93. Set the anti-tilt wires to the locked position and tightening the nuts
Next steps
1.
Replace the processor air
2. Follow the procedure listed in
Expansion cards and expansion card risers
NOTE:
When an expansion card is not supported or missing, the iDRAC and Lifecycle Controller logs an event. This does
not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting
expansion cards section in the PowerEdge Servers Troubleshooting Guide at www.dell.com/poweredgemanuals.
122
Installing and removing system components
shroud.
After working inside your
system.
Advertisement
Table of Contents
