Table of Contents
Advertisement
Figure 119. Installing the power interposer board
3. Reconnect all the required cables.
Next steps
1.
Install the
PSU.
2.
Install the PCI air
shroud.
3. Follow the procedure listed in
Optional OCP card
Removing the OCP riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
cover.
Steps
1. Using a Phillips 2 screwdriver, loosen the captive screw and the two screws on the chassis.
2. Disconnect the signal cable and power cable from the system board connectors.
3. Lift the OCP riser from the OCP riser slot.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
144
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your system
system.
.
Advertisement
Table of Contents
