Table of Contents
Advertisement
Figure 125. Installing the OCP card filler
Next steps
1.
Install the system
cover.
System board
This is a service technician replaceable part only.
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted
to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key.
If you replace this system board, you must supply the recovery key when you restart your system or program
before you can access the encrypted data on your drives.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the following components:
a.
System cover
b.
Expansion card risers
c.
Air shrouds
d.
Memory modules
e.
Processor and heat sink module
f.
BOSS N1 card
g.
OCP riser
h. Disconnect all cables from the system board.
CAUTION:
Take care not to damage the system identification button while removing the system board
from the system.
NOTE:
The procedure to remove the system board is the same for Rear Accessed and Front Accessed configurations.
150
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
