Emerson Rosemount CX1100 Reference Manual page 24

Wire
May 2023
CAUTION
To maintain EMC/EMI noise protection, connect the customer-supplied nine conductor
cable and cable glands properly to ground.
Procedure
1. Run the signal and power cables between the probe and the installation site for the
2. Remove the covers from the probe and the remote transmitter (if applicable).
3. Feed all probe wiring through the conduit port of the probe.
4. Connect probe heater power leads to probe connector.
24
optional remote transmitter.
Refer to Figure 3-1.
Reference Manual
00809-0100-4110
Rosemount CX1100