Protector - Kanomax 3444 User Manual

5.4 Protector

When the dust monitor is mounted on a tripod, a protector (3444-70) can be installed to
cushion the impact on the dust monitor body when overturned.
＜Mounting Instructions＞
Align the tripod fixing screw hole on the side of the dust monitor with the hole on the protector,
place the protector between the dust monitor and the L-shaped tripod fixing angle, and tighten
the screw on the L-shaped tripod fixing angle.
* To use the protector, an L-shaped angle is required for fixing.
* Please prepare the tripod(able to withstand load of 3 kg or more).
* Make sure the dust monitor is oriented correctly so that it can be mounted in the center
of the protector.
* Tighten the screws firmly so that the dust monitor does not tilt.
Tripod fixing screw hole
Tripod Fixing L Angle
Protector
*The protector cannot completely protect the
main body of the dust monitor. Depending on
the operating environment and the degree of
fall, the main unit may be damaged in the drop
even with the protector attached.
*If the protector is deformed due to a fall, it
cannot be reused.
*Be aware that the protector will get very hot if
leave it in direct sunlight.
Protector
58