Workstation malfunction
In the event of a workstation malfunction, please check section 9.6 for a list of common problems
and solutions. If you cannot find a solution to your problem, please contact your local distributor,
quoting the serial number of your workstation.
Common problems and solutions
Workstation general problems
Please consult the list shown below as a reference in the event of a malfunction of your workstation.
Figure 35: Common problems and solutions
Problem
The workstation will not
switch on
The workstation
temperature will not go
above ambient plus 5
Devices plugged into the
internal socket (if fitted) are
not powering up
The internal light does not
illuminate when switched
on
Plates are drying out
Cause
The workstation is not
plugged in
The mains socket is not
switched on
The mains plug fuse
has blown
The mains fuse has
blown
The heater mat
thermal protection
C
switch has activated
o
The heater mat fuse
has blown
The power switch on the
device is not switched
on
The plug for the device
is not fully inserted into
the socket
The fuse in the device
has blown and/ or the
device has failed
The internal socket fuse
has blown
The bulb has blown
The fuse has blown
Too
little
inside workstation
Solution
Plug the workstation into the mains
Switch the mains power on
UK users: Replace the mains plug fuse
(see section 9.2.2, for more details)
Replace the mains fuses. See section
9.2.3 for more details.
Wait for the heater mat thermal
protection switch to reset.
Contact your local distributor
Turn the power switch on the device on
Check that the plug is correctly
inserted into the socket
Plug the device into another socket. If
the device fails to power up, the fuse
has blown and/ or the device has
failed. Refer to the owner's manual for
the device.
Contact your local distributor
Contact your local distributor to
arrange replacement
humidity
Place a tray of water inside the
workstation as a water source.
Page 52 of 55
Need help?
Do you have a question about the Bugbox Ax and is the answer not in the manual?