Huawei UPS5000-E-40 kVA Quick Manual page 4

Non-Secured Installation
1. Wrench an anchor bolt clockwise to elevate a cabinet , or wrench an anchor bolt anticlockwise
to lower it. The cabinet feet can be adjusted within a range of 0–8 mm.
2. To prevent cabinet tilting and damage, adjust all the feet at the four corners instead of one foot.
3. Use a measuring tape for measurement when leveling the cabinet to ensure that the height
between the cabinet top and the ground is 2000 + 3 mm.
4. Do not remove anchor bolts. Otherwise, you need to rework them for use.
1. Lower the four leveling feet at the bottom of the
cabinet by using a wrench until all the four
castors at the bottom hang in the air, the leveling
feet bear the whole cabinet weight, and the
integrated UPS height is 2000 mm.
2. Check whether the bottom of the cabinet is
horizontal by using a level. If the cabinet is not
leveled, adjust the leveling feet.
Installing the UPS on an ESD Floor
Installing a Support
Secure the support to the concrete floor using fasteners and ensure the upper surfaces of the
support are at the same level.
Securing the Cabinet
1. Lift the UPS onto the support and align the mounting holes on the UPS with those on the support.
2. Level the UPS by adjusting the anchor bolts, as shown by (1) in the Figure.
1. Wrench an anchor bolt clockwise to elevate a cabinet , or wrench an anchor bolt anticlockwise
to lower it. The cabinet feet can be adjusted within a range of 0–8 mm.
2. To prevent cabinet tilting, adjust all the feet at the four corners instead of one foot.
3. Check that the vertical distance between the top of the cabinet and the ESD floor is 2000 + 3
mm.
4. Do not remove anchor bolts. Otherwise, you need to rework them for use.
3. Insert four M12 bolt assemblies
equipped with spring washers
and flat washers into the
mounting holes for the support
and UPS. Tighten the bolts, as
shown by (2) in the Figure.
•
The figures are for reference
only. The actual product
appearance prevails.
•
Find the bolts used in this step in
the fitting bag delivered with the
cabinet.
(1) Anchor bolt (2) Fixing bolt
4
(3) Level