Connecting Cables - Huawei UPS5000-E-40 kVA Quick Manual

5. Install the cabinet rear door and accessories at the corresponding positions on the tail frame.
After installing the cabinet rear door, adjust tail frame anchor bolts and ensure that anchor bolts touch
the floor. Verify that ground cables are properly connected to the cabinet and cabinet rear door.
4
(Optional) Combining Cabinets
The figures are for reference only. The actual product appearance prevails.
1. Open the front and rear doors. Wrench the
anchor bolts using an adjustable wrench to
adjust the cabinet height, as shown in the
figure. Use a level to level the cabinet.
4. Use the same method to secure the connecting kits in the connection positions on the rear door.
5 5

Connecting Cables

1. Remove the screw from the supporting kit of the connecting kit to secure the connecting kit.
2. A UPS cabinet in the middle position has four connecting points on each of the front and rear
doors. An end UPS cabinet has two connecting points on each of the front and rear doors.
5. Repeat the procedure to combine other cabinets.
NOTE
When combining cabinets, ensure that: all cabinet surfaces are at the same level.
6. Secure the bolts using a socket wrench.
5
Connecting Cables
When connecting the mains input power cable, strip the outer layer of the 5-wire cable, wrap
each wire in the stripped section using corrugated pipes which are available in the fittings
bag, and secure the corrugated pipes using insulation tape to prevent sliding.
2. Remove the cabinet connecting kits from the
rack, as shown in the figure.
3. Secure the connecting kits in the connection
positions on the front door using screws, as
shown in the figure.
6