Table of Contents
Advertisement
A. SIP / Network Alarm
If there is a network error or the unit cannot register to the SIP Server/Provider the blue LED on the button will blink on
and off every 2 seconds, and three error beeps will be heard every 30 seconds until the problem is resolved. This is to
alert users to a potential problem that may prevent the X-Series device from making an outbound call.
B. Muting the SIP / Network Alarm
These beeps can be temporarily or permanently disabled. To mute the Alarm press and hold the button for at least 5
seconds (2 beeps will be heard indicating when to release it). This mutes the beeps until the next reboot, power cycle,
or a change in registration/network status. The beeps can be permanently disabled on the Configure Tab under "Phone
Settings". Set the Alarm Mute setting to "Disabled" and the beeps will be disabled for all "Alarm" conditions. The LED
will continue flash when the unit's "Alarm" is active even if the beeps are muted.
15 - Troubleshooting
29
Advertisement
Table of Contents
