Table of Contents
Advertisement
Raptor MicroATX – Installation Guide
Memory Test
This option configures the test that will be performed on the
Low memory (below 1 MB) and the High Memory (above
1MB). The settings are Full (exhaustive testing), Standard, and
Fast. The default is StdLo and FullHi.
Loader
Parity Checking
Debug Breakpoints
Debugger Hex Case
These options are not available.
Show "Hit Del"
Set this option to Disabled to prevent the message
from appearing on the first BIOS screen when the computer
boots. The setting is either Disabled or Enabled. The default
setting is Enabled.
F1 Error Wait
If this option is set to Enabled, the BIOS waits for the user to
press <F1> before continuing. If this option is set to Disabled,
the BIOS continues the boot process without waiting for <F1>
to be pressed.
Configuring Floppy Drive Types
Choose either Floppy Drive 0 or 1 to specify the floppy drive
type. The settings are 360 KB 5¼", 1.2 MB 5¼", 720 KB 3½",
1.44 MB 3½" and 2.88 MB 3½".
Floppy0 refers to the first floppy disk drive on the drive ribbon
cable (normally drive A:), and Floppy1 refers to the second drive
(drive B:).
20
Hit <DEL> if you want to run Setup
Advertisement
Table of Contents
