Table of Contents
Advertisement
discretion. The warranty is void if the product has been subjected to
alteration, misuse or abuse; if any repairs have been attempted by
anyone other than the manufacturer; or if failure is caused by accident,
acts of God, or other causes beyond the manufacturer's control.
Raptor MicroATX - An Overview
The Raptor MicroATX represents the ultimate in industrial embedded
motherboard technology. No other system board available today
provides such impressive list of features:
CPU Support
•
Supports full series of Intel Celeron (FC-PGA 66MHz PSB,
FC-PGA 100MHz PSB and FC-PGA2 (0.13u) 100MHz PSB) and
Pentium III (FC-PGA 100MHz PSB, FC-PGA 133 PSB and FC-
PGA2 (0.13u) 133MHz PSB) PGA370 processors.
Supported Bus Clocks
•
66MHz, 100MHz and 133MHz.
Memory
•
Two DIMM sockets up to 512MB (unbuffered) SDRAM,
PC100 and PC133 (recommended for higher performance when
using 133MHz PSB processors).
On-Board I/O
•
2 Floppies up to 2.88 MB.
•
Dual channel PCI 32-bit EIDE controller – UDMA 66/100
supported. One extra connector (mini-Header 44 pin) in parallel to
IDE1 for Solid State IDE disk or any 44 pin IDE device support.
•
Four high speed RS-232 (or two RS-232 and two RS-422/485
(optional)) serial ports 16 Bytes FIFO (16550/16550D). RS-
422/485 Full duplex or Half-duplex (RTS flow control),
termination resistors on/off, transient suppression on transmitter
lines.
Introduction
VII
Advertisement
Table of Contents
