Functional Description; Indication Lamp - Makita PC5010C Instruction Manual

Additional Safety Warnings:
1. Always install the dust collecting wheel guard
before operation.
Be careful not to damage the spindle, the
2.
flange (especially the installing surface) or the
lock nut. Damage to these parts could result in
wheel breakage.
3. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
Before using the tool on an actual workpiece,
4.
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced wheel.
Do not leave the tool running. Operate the tool
5.
only when hand-held.
6. Do not touch the cup-type diamond wheel
immediately after operation; it may be
extremely hot and could burn your skin.
7. Observe the instructions of the manufacturer
for correct mounting and use of wheels.
Handle and store wheels with care.
8. Do not use separate reducing bushings or
adaptors to adapt large hole cup-type diamond
wheels.
9. Use only flanges specified for this tool.
10. Check that the workpiece is properly
supported.
11. Pay attention that the wheel continues to
rotate after the tool is switched off.
12. If working place is extremely hot and humid,
or badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure opera-
tor safety.
13. Do not use the tool on any materials contain-
ing asbestos.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.

Indication lamp

Fig.1
► 1. Indication lamp
The indication lamp lights up green when the tool is
plugged.
If the indication lamp does not light up, the mains cord
or the controller may be defective.
The indication lamp is lit but the tool does not start even
if the tool is switched on, the carbon brushes may be
worn out, or the controller, the motor or the ON/OFF
switch may be defective.
Shaft lock
WARNING:
Never actuate the shaft lock when
the spindle is moving. It may cause serious injury or
the tool damage.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
1
Fig.2
► 1. Shaft lock
6 ENGLISH
1