Functional Description - Makita 1002BA Instruction Manual

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting front base
1
2
► 1. Wing bolt 2. Front base 3. Wing bolt
The front base is factory-adjusted to allow concave cuts
with a radios of 320 mm (12 - 5/8"). For concave cuts
with the tool's minimum radios of 300 mm (11 - 3/4")
loosen the wing bolt on either side and raise the front
base as far as it will go. Then retighten the two wing
bolts firmly to secure the front base.
Adjusting depth of cut
► 1. Knob
Depth of cut may be adjusted by simply turning the knob
on the front of the tool.
Switch action
1
► 1. Switch trigger 2. Lock button
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
• Switch can be locked in "ON" position for ease
3
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
4 ENGLISH
1
2