Makita PC5010C Instruction Manual page 8

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Installing or removing loop handle
CAUTION:
Always install the loop handle
before operation.
CAUTION:
Always be sure the bolts on the
loop handle is securely tightened before use.
CAUTION:
Hold the gripping area of the loop
handle specified in the figure. Also, keep the
hand away from the metal part of the tool during
operation. Touching the metal part may result in
electric shock, if the cutting attachment cuts live wire
unexpectedly.
To install the loop handle, mount it onto the tool as
illustrated and tighten two bolts to fix it.
To remove the loop handle, follow the installation proce-
dure in reverse.
Fig.6
► 1. Bolt 2. Gripping area
Installing or removing dust
collecting wheel guard
WARNING:
Always switch OFF and unplug
the tool before attaching dust collecting wheel
guard.
WARNING:
Dust collecting wheel guard is
only for use in planing concrete surface with a
cup-type diamond wheel. Do not use this guard
with any other cutting accessory or for any other
purpose.
WARNING:
Inspect dust collecting wheel
guard thoroughly before use to ensure that it is
not damaged, cracked and/or deformed.
2
1
1. Loosen the attaching screw on the dust collecting
wheel guard until attaching slot opens.
1
Fig.7
► 1. Attaching screw
2.
Make sure that the front-edge cover is in the
closed position.
3. Mount the dust collecting wheel guard with the
protrusions aligned with the notches on the bearing box.
2
1
Fig.8
► 1. Notch 2. Protrusion
4. Turn the dust collecting wheel guard in direction of
the arrow, and tighten the attaching screw to secure.
Fig.9
To remove the dust collecting wheel guard, follow the
installation procedure in reverse.
8 ENGLISH