21. Do not leave the tool running. Operate the tool
only when hand-held.
22. Do not touch the offset diamond wheel
immediately
after
extremely hot and could burn your skin.
23. Observe the instructions of the manufacturer
for correct mounting and use of wheels.
Handle and store wheels with care.
24. Do not use separate reducing bushings or
adaptors to adapt large hole wheels.
25. Use only flanges specified for this tool.
26. Pay attention that the wheel continues to
rotate after the tool is switched off.
27. If working place is extremely hot and humid,
or badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure
operator safety.
28. Do not use the tool on any materials
containing asbestos.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
operation;
it
may
FUNCTIONAL DESCRIPTION
be
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
004759
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Level planing
1
2
004760
To level a surface, the base of the planer should be
aligned with the diamond wheel. The front roller should
be adjusted (use hex wrench) upward to the level
required for the desired stock removal amount.
To change the amount of stock (concrete) removed,
loosen the hex socket head bolts on the grip holder with
the hex wrench. Raise or lower the front roller to adjust
the gap between it and the diamond wheel. The
difference is the stock removal amount. Then secure the
hex socket head bolts very carefully.
6
1. Switch trigger
2. Lock button
1
2
1. Front roller
2. Hex wrench
3. Base
3