Camera Recording Card Recording - Sharp VL-ME10E Operating Manual

Digital Still Camera Features
Digital Still Camera Features
Camera Recording
Camera Recording
Card Recording
Available mode: CARD-CAMERA
It is possible to take a still picture in the same
way as you do with a standard camera and
record that image on the card.
Media Selection switch
Power Zoom buttons
STILL button
POWER switch
1
Insert a card in the camcorder (see
page 15).
2
Remove the lens cap. Pull out the
viewfinder completely or open the LCD
monitor.
3
Set the Media Selection
switch to CARD.
4
Hold down the Lock button and set the
POWER switch to CAMERA.
• The camcorder turns on in CARD-
CAMERA mode, and the picture from the
lens is displayed on the screen.
AUTO
Lock button
73
All manuals and user guides at all-guides.com
Number of shots taken
CARD
1 0 9 0
NORMAL
GAMMA GAMMA GAMMA
Number of shots remaining
5
Press the Power Zoom buttons to frame
the subject as you desire.
Note: In CARD-CAMERA mode, the zoom will
give magnification of 1–10×.
6
Press the STILL button to record a still
image of the subject.
• The O indicator flashes red while data is
being recorded on the card, and returns
to white when recording is completed.
AUTO
Notes:
• In CARD-CAMERA mode, the angle of field is
slightly wider than in TAPE-CAMERA or DUAL-
CAMERA mode.
• Recording under insufficient lighting may result
in blurred images. It is recommended that you
use a tripod to record insufficiently illuminated
subjects.
• Recording under the light of a fluorescent,
mercury, or sodium lamp may cause flickering in
the image and, depending on the timing of the
shot, may result in changes to colour hue in the
image.
• It is also possible to record still images on a card
by pressing the CARD REC button on the
infrared remote control.
Caution:
• Do not turn the power off or remove the card
while the O indicator is flashing in step 6,
because this may delete or damage images on
the card.
CARD
1 1 8 9
NORMAL
GAMMA GAMMA GAMMA