Safety Notes
■
ALWAYS:
•
Connect to a grounded circuit.
•
Connect to operating voltages as specified on the product's spec sticker.
•
Disconnect from power before replacing the fuse.
•
Disconnect from its power source during periods of inactivity.
•
Use a safety cable when suspending overhead.
•
Heed all restrictions and warnings on the spec sticker.
•
Mount in a location with at least 20 in (50 cm) of ventilation.
•
Replace the fuse with the same type and rating.
•
Use a clamp with a captive bolt when a single hanging bracket is used.
■
In the event of a serious operating problem, stop using immediately.
■
DO NOT:
•
Open this product or attempt any repairs. It contains no user-serviceable parts.
•
Look at the light source when the product is on.
•
Use if the power cord is crimped or damaged.
•
Disconnect by pulling on the power cord.
•
Allow flammable materials close to the product when it is operating.
•
Touch the housing when it is on.
•
Block any ventilation holes/slots in the housing.
•
Connect to a dimmer or rheostat.
•
Carry the product by its power cord.
•
Operate in temperatures higher than 104°F (40°C).
•
Expose to environments that exceed the Ingress Protection (IP) rating.
•
Expose to rain or moisture.
•
Use outdoors.
•
Expose to corrosive environmental conditions such as temperature, humidity, salinity,
pressure, radiation, or shock.
•
Set this product on a flammable surface.
Keep this User Manual for future use. If the product is sold to someone else, be sure that they
also receive this document.
2
Before You Begin
Intimidator Scan 360 User Manual Rev. 3