Master/Slave Mode - Chauvet DJ INTIMIDATOR SCAN 360 User Manual

Operation

Master/Slave Mode

The Master/Slave mode allows a single Intimidator Scan 360 product (the "master") to control the actions
of one or more Intimidator Scan 360 products (the "slaves") without the need of a DMX controller. The
master product will be set to operate in either standalone mode or with the IRC-6, while the slave products
will be set to operate in slave mode. Once set and connected, the slave products will operate in unison with
the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Slave.
5. Press <ENTER>.
6. Connect the DMX input of the first slave product to the DMX output of the master product.
7. Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
8. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to operate in standalone mode.
2. Make the master product the first product in the DMX daisy chain.
• Configure all the slave products before connecting the master to the daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.
• Do not connect more than 31 slaves to the master.
Intimidator Scan 360 User Manual Rev. 3 13