Daikin Clima-Flex CLIC STAND ALONE Series Installation, Operation And Maintenance Manual page 30

• This parameter is the current setpoint in COOL mode but read
only.
• Press the down arrow key and the SEtC parameter will
appear. This parameter is the cooling Setpoint to change from
here you can change the Setpoint in COOL mode.
• Press the PRG or circle key: the value on the display will
change from static to flashing, at which point you can press
the up or down keys to change the setpoint. Once the desired
change has been made, momentarily press the PRG or circle
key to confirm and save the change.
• Press the down key again and the SEtH menu will appear,
this parameter is used to change the setpoint in HEAT mode
only when the units have this option available otherwise it will
not appear.
• Press the down key again and the UnST menu will appear,
from here you can turn the unit on or off. In some units
this parameter is not available because currently there is a
switch on the panel to turn the unit on or off, otherwise, this
parameter is also linked in the application from the cell phone
to be able to turn on or off.
iom-clicsa-cf-eng
• Press the down key again and the UON menu will appear,
from here you can change the units of measurement.
• After the parameters have been set, the output screen will
appear on the main screen.
30
Controller Use
www.clima-flex.com