Flashforge Adventurer 4 Pro User Manual page 5

Personal Safety
Do not touch the nozzle and build plate during printing.
Do not touch the nozzle and plate after printing to avoid high-temperature scalds
or mechanical damage!
Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
gloves away from moving parts.
Do not operate the device while you are tired or under the influence of drugs,
alcohol or medication.
Keep body parts away Warning crushing Hot surface Keep this area
from moving parts of hands Do not touch clear
Cautions
Keep the inside of the device clean and tidy. Do not place metal objects into the
chute at the bottom of the platform.
Please clean up the filament debris in time. It is recommended to operate this
outside the equipment.
Any modifications to the device will invalidate the guarantee.
Lower the build plate before loading/unloading filament. The distance between
the nozzle and build plate should be kept for at least 50mm.
Operate the device in a well-ventilated environment.
Never use the device for illegal activities.
Never use the device to make any food containers.
Never put the prints into your mouth.
Environment Requirements
Temperature: RT 15-30℃; moisture: 20%-70%.
Placement Requirements
The device must be placed in a dry and ventilated environment. The distance of
the left, right and back side space should be at least 20cm, and the distance of the
front side space should be at least 35cm. Device storage temperature: RT 0-40℃.
03