Filament - Flashforge Adventurer 4 Pro User Manual

6.2.2 Filament

Load/Change/Manual
Load
Click [Load], and the extruder will be heated up to the preset temperature. Then follow
the instructions to finish loading. Note that the automatic mode adopts the fast + slow
feeding. Just place the filament at the filament feeding wheel. When in the automatic
mode, do not push the filament into the guide tube. It is easy to cause abnormal
sound when the filament is fed too fast.
Change
Click [Change], and the extruder will be heated up to the preset temperature. Pull out
the filament according to the instruction. Insert the new filament into the filament
intake until some resistance is felt. New filament coming out of the extruder indicates
a successful replacement.
Note
The extruder will be heated to the
highest temperature by default during
automatic filament feeding and
withdrawing. Actually, the extruder
heating temperature can be adjusted
according to the used filament when
in practical use.
Manual
Click [Manual], and the extruder will be heated up to the preset temperature. Choose the
filament length, and choose [Load/Unload].
Note that the manual mode should be preferred when there is remaining
Note
filament in the tube.
240
℃
240
℃
20