Technical Data; Transportation; Transportation In Vehicle; Starting Operation - WAGNER ProSpray 26 Operating Manual

Description of unit
3.5 Technical data ProSpray 26
Voltage:
Max. current consumption:
220~240 V AC
100~120 V AC
Power cord:
Acceptance capacity:
Max. operating pressure:
Volume flow at 12 MPa
(120 bar) with water:
Max. tip size:
Max. temperature of the
coating material:
Max. viscosity:
Filter insert
(standard outfitting)
Weight:
Special high-pressure hose: DN 6 mm, 15 m connecting
Dimensions (L x W x H)
Upright cart unit:
Low boy cart unit:
Stand unit
Max. sound pressure level:
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.

3.6 Transportation

Pushing or pulling the unit
Pull out the handle (Fig. 3, Item 1) until it will come no further.
Insert the handle – push the buttons (2) on the spars, and then
push in the handle.
2
30
220~240 V AC, 50/60 Hz or
100~120 V AC, 50/60 Hz
8.5 A
14 A
3 x 1.5 mm 2 – 6 m
1725 Watts
23 MPa (230 bar)
2.64 l/min
0.026 inch – 0.66 mm
43°C
25.000 MPa·s
60 mesh
25 kg
thread M 16 x 1.5
580 x 565 x 760 mm
820 x 430 x 545 mm
480 x 345 x 405 mm
80 dB (A) *
1
2
GB

3.7 Transportation in vehicle

Roll the high-pressure hose over the suspension device at the
handle.
Secure the unit with a suitable fastening.

4. Starting operation

4.1 High-pressure hose, spray gun and
separating oil
1. Screw the high-pressure hose (2) to the coating material
outlet (Fig. 4, Item 1).
2. Screw the spray gun (3) with the selected tip onto the
high-pressure hose.
3. Tighten the union nuts at the high-pressure hoses firmly so
that coating material does not leak.
1
2
EasyGlide prevents increased wear and
tear to the packings.
Attention
Starting operation
3
ProSpray 26