Technical Data - WAGNER W 540 Operating Instructions Manual

W 540
Problem
Coating
material drips
from the nozzle
Atomisation too
coarse
Spray jet
pulsates
Coating
material causes
"paint tears"
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose

18. Technical Data

Max. viscosity
Power source
Power consumption
Atomizing output:
Protection Class:
Sound pressure level*
Sound pressure output*
Oscillation level*
Weight
Cause
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
•
Viscosity of coating material too
high
•
Material volume too large
Material volume adjusting screw
turned too far to the right (+)
•
Nozzle contaminated
•
Air filter heavily soiled
•
Too little pressure build-up in
container
•
Coating material in container
running out
•
Air filter heavily soiled
•
Nozzle seal is missing or worn
•
Too much coating material
applied.
•
Distance to the object too large
•
Too much coating material
applied
•
Diaphragm soiled
•
Diaphragm defective
Technical Data
90 DIN-s
230 V , 50 Hz
~
280 W
65 W
I
79 dB (A); Uncertainty K = 4 dB
92 dB (A); Uncertainty K = 4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
1,3 kg
Remedy
➞ Tighten
➞ Change
➞ Insert an intact nozzle seal
➞ Clean
➞ Thin
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean
➞ Change
➞ Tighten container
➞ Refill
➞ Change
➞ Insert an intact nozzle seal
➞ Turn material volume
adjusting screw to the
left (-)
➞ Reduce distance
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean the diaphragm
➞ Replace the diaphragm
GB
25