Technical Data - Graco Dispensit 710 Instructions Manual

Technical Data

NOTE: See feed system manuals for dimensions, weights, and wetted parts lists for those components. Dimensions,
weights, and wetted parts for components not covered in component feed system manuals and for combined assem-
blies are listed below.
Maximum Ambient Temperature . . . . . . . . . . . . . . . . . . . 110°F (43°C)
Maximum Operating Temp . . . . . . . . . . . . . . . . . . . . . . . . 150°F (65°C)
Maximum Outlet Material Working Pressure . . . . . . . . . . 1200 psi (8.27 MPa, 82.7 bar)
Maximum Air Working Pressure . . . . . . . . . . . . . . . . . . . . 100 psi (0.7 MPa, 7 bar)
Minimum Air Working Pressure . . . . . . . . . . . . . . . . . . . . 70 psi (480 kPa, 4.8 bar)
Maximum Material Inlet Pressure . . . . . . . . . . . . . . . . . . . 1200 psi (8 MPa, 83 bar)
Supplied Air Requirements. . . . . . . . . . . . . . . . . . . . . . . . 1 to 3 cfm at 80 psi to 100 psi
Shot Size Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.002 cc continuous
Maximum Cycle Rate (application dependent). . . . . . . . . Up to 60 cycles per minute
Dimensions (H x L x W), height to end of material inlet
block . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.46 x 1.68 x 0.75 in. (139 x 43 x 19 mm)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 4 lb (0.91 - 1.81 kg)
Wetted Parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Metering Valve: 303/304, 404, fluoroelastomer, EPDM
332094C
Graco-supplied Feed System Assemblies
(depends on selected options):
Smallest: 22.5 x 10 x 4 in. (572 x 254 x 102 mm)
Largest: 60 x 28 x 19 in. (1524 x 711 x 483 mm)
Graco-supplied Feed System Hoses and Fittings: Mild
steel, 303/304, PTFE, buna, polyethylene, polypropyl-
ene
Graco-supplied Tanks: Polyethylene, 303/304, mild steel
Technical Data
21