Removing The Front Bezel; Replacing The Power Switch Board - Lenovo E50–05 Series Hardware Maintenance Manual

Table of Contents

Removing the front bezel

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.

Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo

recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches

or other damage.

To remove the front bezel:

Step 1.

Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating

system, and turn off the computer and all attached devices.

Step 2.

Unplug all power cords from electrical outlets.

Step 3.

Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)

cables, and any other cables that are connected to the computer. Refer to "Left and right view"

and "Rear view" for help with locating the various connectors.

Step 4.

Remove the computer cover. Refer to "Removing the computer cover".

Step 5.

Remove the front bezel by releasing the three plastic tabs inside the chassis and pushing the

bezel outward as shown.

Step 6.

To reattach the bezel:

Align the plastic tabs on the bottom of the bezel with the corresponding holes in the chassis,

and then snap it into position at the bottom and top of the chassis.

Step 7.

Reattach the computer cover.

Note: For this procedure, it helps to lay the computer flat.

Lenovo E50–05 Series Hardware Maintenance Manual

Table of Contents