Toro 41393TE Software Manual page 25

2. Press button 4 to select
(Figure 70).
3. Press buttons 1 or 2 to navigate to the
option (Figure 71).
Figure 71
4. Press buttons 3 or 4 to raise or lower the
simulated speed (Figure
5. Press button 2 to navigate to the
(Figure 72).
Figure 72
calibration option
SPEED
SPEED
g193671
71).
/ option
ON OFF
g193669
g193670
6. Press button 4 to toggle O
speed simulation
7. Press button 5 to save your settings and exit the
screen, and return to the
TEST SPEED
screen (Figure
Using the Manual Cal Entry
Use the manual cal entry screen to view the calibration
values for 3-sprayer section (boom), 2-sprayer section
(boom), 1-sprayer section (boom), and the speed.
Important:
These calibration entries are the
numbers used for calculating the flow and speed
correction factors. Do not change these numbers.
Use the Flow Calibration (page 14)
Calibration (page 22)
1. Press buttons 1 or 2 on the
to navigate to the
(Figure 73).
2. Press button 4 to select Speed calibration option
(Figure 73).
3. Press buttons 1 or 2 to select the boom flow or
speed option
25
or O
N FF
(Figure 72).
72).
and
procedures.
CALIBRATE
MANUAL CAL ENTRY
Figure 73
(Figure 74).
the test
CALIBRATE
Speed
sub-menu
option
g193322