Toro 41393TE Software Manual page 21

If the calibration value is out of bounds
(Figure 57), contact your authorized Toro
service dealer; otherwise, review the error
message and repeat the calibrations steps
in Preparing for the Catch Test (page
Performing the Sprayer Section Catch Test
(page 18), and
Calculation (page
3. Press button 5 to exit the Speed Calibration
screen (Figure 55,
4. Move the throttle to the I
engine, and remove the ignition key.
Performing the 2 Sprayer-Section Calibration
If you completed a 3-sprayer-section calibration,
the Infocenter prompts you for a 2-sprayer-section
calibration (Figure 58), perform 1 of the following:
•
If you do not need to perform the 2-sprayer-section
calibration, press button 5 to return to the Calibrate
screen (Figure 58).
•
Press button 2 to proceed to the calibration steps
in Preparing the Sprayer Section(s) for the Catch
Test (page 17).
Performing the Calibration
20).
Figure 57
Figure 56, and Figure
position, shutoff the
DLE
Figure 58
Note:
You will set only the sprayer section
switches
identified for calibration in
Type of Flow Calibration to Perform (page
16),
Performing the 1-Sprayer-Section Calibration
If you completed a 3-sprayer-section calibration and
2-sprayer-section calibration, the Infocenter prompts
you for a 1-sprayer-section calibration
perform 1 of the following:
g192864
57).
•
If you do not need to perform the 1-sprayer-section
calibration, press button 5 to return to the Calibrate
screen (Figure
•
Press button 2 to proceed to the calibration steps
in Preparing the Sprayer Section(s) for the Catch
Test (page
Note:
You will set only the sprayer section switch
(Figure 38) to the O
for calibration in
Flow Calibration to Perform (page
g192943
21
(Figure 38) to the O
N
Evaluating the Which
Figure 59
59).
17).
position that you identified
N
Evaluating the Which Type of
position that you
15).
(Figure 59),
g192942
15).