Toro 41393TE Software Manual page 18

Figure 47
1. Left spray-section switch
2. Center spray-section
switch
2. Press button 2 to advance to the next step
(Figure 47).
3. At the Repeat the Following Test screen, press
button 2 to start the sprayer section catch test
(Figure 48).
g192867
g192944
3. Right spray-section switch
4. Master section switch
Performing the Sprayer Section Catch Test
Note:
Ready the graduated catch container.
1. Set the master section switch to the O
(Figure 47).
2. Use the application-rate switch to adjust the
sprayer system pressure to approximately 276
kPa (40 psi); refer to
1. Pressure gauge (sprayer
system)
3. Set the master section switch to the O
(Figure 47).
4. At the catch test playback screen, confirm the
number of booms, the nozzle color, and press
button 3 to start the catch test
Note:
You have 14 seconds to move to the
back of the machine and position the graduated
catch container under a spray nozzle for the
catch test period.
18
Figure 48
N
Figure 49.
Figure 49
2. Application-rate switch
FF
(Figure 50).
g192945
position
g192699
position