Toro 41393TE Software Manual page 24

Figure 67
1. Measured-distance value
•
A message displays confirming that the
speed calibration is successful
Figure 68
•
A message displays indicating that the speed
calibration is failed
Note:
Press button 5 to exit the Speed
Calibration screen.
Note:
If the calibration value is out of bounds
(Figure 69), contact your authorized Toro
service dealer; otherwise, review the error
message and repeat the calibration steps in
Preparing for the Speed Calibration (page
22) and Performing the Speed Calibration
(page 23).
g192380
2. Entered-distance value
(Figure 68).
g192425
(Figure 69).
5. Press button 5 to exit the Speed Calibration
screen (Figure 68
6. Move the throttle to the S
off the engine, engage the parking brake, and
remove the ignition key.
Test Speed
Use the test speed feature to simulate a ground speed
signal for stationary sprayer operation for the following
tests:
•
Setting the section-bypass valves (manual mode),
refer to the Operator's Manual for the machine.
•
Verify the catch test for machines operated in the
application-rate mode.
Note:
If you release the parking brake or move the
machine while using the speed test simulation, the
InfoCenter exits the simulation.
Using the Test Speed
1. Press buttons 1 or 2 on the
sub-menu to navigate to the
(Figure 70).
24
Figure 69
or Figure 69).
position, shut
LOW
CALIBRATION
TEST SPEED
Figure 70
g192424
option
g193668