Table of Contents
Advertisement
7.
Mark a finishing line on a testing area of turf
(Figure
33).
8.
Press button 2 to move the next step
9.
Enter the Use buttons 3 or 4 to change the
entered-distance value the InfoCenter and press
button 2
(Figure
Figure 65
1. Entered-distance value
Performing the Speed Calibration
1.
Move the machine to align the front tires on the
starting line.
2.
At the center console of the machine, ensure
that the switches for the 3 section valves are in
the O
position.
FF
(Figure
65).
64).
g192348
1. Left-section switch
2. Center-section switch
3.
Press button 2 on the InfoCenter and drive to
the finishing line
Note:
The measured-distance value should
rise.
4.
Press button 2 (D
machine is on the finish line
Note:
If the measured-distance value and
the entered-distance value do not match, the
computer of the sprayer system automatically
corrects the measured-distance value.
23
Figure 66
3. Right-section switch
(Figure 66
and
Figure
) when the front tire of the
ONE
(Figure
67).
g192356
g192354
63).
Advertisement
Table of Contents
