Standards - Siemens SINAMICS G120P Hardware Installation Manual

EMC Phenomenon
Mains Interruptions & Voltage
Dips
Voltage Distortion
Voltage Unbalance
Frequency Variation
Commutation Notches
Note
The immunity requirements apply equally to both filtered and unfiltered units.
A.4

Standards

European Low Voltage Directive
The SINAMICS G120 product range complies with the requirements of the Low Voltage Directive
2006/95/EC. The units are certified for complaince with the following standards:
EN 61800-5-1 — Semiconductor inverters –General requirements and line commutated inverters
EN 60204-1 — Safety of machinery –Electrical equipment of machines
European Machinery Directive
The SINAMICS G120 inverter series does not fall under the scope of the Machinery Directive. However,
the products have been fully evaluated for compliance with the essential Health & Safety requirements of
the directive when used in a typical machine application. A Declaration of Incorporation is available on
request.
European EMC Directive
When installed according to the recommendations described in this manual, the SINAMICS G120 fulfils
all requirements of the EMC Directive as defined by the EMC Product Standard for Power Drive Systems
EN 61800-3
ISO 9001
Siemens plc operates a quality management system, which complies with the requirements of ISO 9001.
Certificates can be downloaded from the internet under the following link:
http://support.automation.siemens.com/WW/view/en/22339653/134200
(http://support.automation.siemens.com/WW/view/en/22339653/134200)
Power Module PM230 IP55
Hardware Installation Manual, 2010-07-02, A5E02923635A AB
Standard Level
EN 61000-4-11
95% dip for 3 ms
30% dip for 10 ms
60% dip for 100 ms
95% dip for 5000 ms
EN 61000-2-4 10% THD
Class 3
EN 61000-2-4 3% Negative Phase Sequence A
Class 3
EN 61000-2-4 Nominal 50 Hz or 60 Hz
(± 45%)
Class 3
EN 60146-1-1 Depth = 40%
Class B
Area = 250% x degrees
Appendix
A.4 Standards
Performance
Criterion
A
C
C
C
A
A
A
85