TOHATSU M 2.5A 2 Owner's Manual page 52

52
INSPECTION AND MAINTENANCE
ENOW00066-1
Do not carry or store outboard motor in any
of positions described below.
Otherwise, engine's exterior parts may be
damaged or water may enter the cylinder
through the exhaust port and cause engine
problems.
ENON00021-3
Note
If the outboard motor must be laid down,
be sure that fuel is completely drained,
then lay the outboard motor with port side
down on the cushion as shown in the
drawing.
10
1. Handle
ENOM00950-A
Adding a fuel stabilizer
When adding a fuel stabilizer additive
(commercially available), first fill the fuel
tank with fresh oil and fuel. If the fuel
tank is only partially filled, air in the tank
may deteriorate the fuel during storage.
1. Before adding fuel stabilizer additive,
drain the carburetor (See page 52).
CAUTION
ENOF02035-0
1
ENOF02037-0
2. Follow the instructions on the label
when adding the fuel stabilizer addi-
tive.
3. After adding the additive, let the out-
board motor run in water for 10 min-
utes to make sure any old fuel in the
fuel system has been completely
replaced by the fuel with additive.
4. Turn the engine OFF
ENON00891-1
Note
If your motor is used occasionally, it is rec-
ommended to use a high quality fuel stabi-
lizer for the fuel and keep the fuel tank full
to reduce condensation and evaporation.
ENOM00970-C
Fuel system draining
ENOW00028-A
WARNING
For details on handling fuel, contact an
authorized dealer.
Fuel and fuel vapors are extremely flamma-
ble and can be explosive.
If fuel is spilled, wipe it up immediately.
Keep the fuel tank well away from sources
of ignition, e.g. sparks or open flames
Perform all work outdoors or in a well
ventilated place.
ENOW00097-0
WARNING
Be sure to use cloth to remove fuel remain-
ing in the cowl and dispose of it in accor-
d an c e w i t h l o c a l f ir e p r e v e n t i o n an d
environment protection regulations.