TOHATSU M 2.5A 2 Owner's Manual page 24

24
PRE-OPERATING PREPARATIONS
1–10
min
Throttle
Idle
Position
1
Crusing
Speed at
minimu
m speed
6
4
3
2
1
ENOW00023-1
Operating the outboard motor without
break-in can shorten life of the product.
If any abnormality is experienced during the
break-in:
Discontinue the operation immediately.
Have the dealer check the product and
take proper action(s) if necessary.
10 min – After
3–5 hrs
3 hrs 5 hrs
Less Less
than 1/2 than 3/4 throttle
throttle throttle available
2
Approx. 3 Abailabl
500- Approx.
3,500 4,000 operate
-1 -1
min min at wide
(rpm) (rpm) open
max throttle
ENOF02010-1
CAUTION
ENOM01004-0
Fuel mix ratio for break-in
Gasoline 25: Genuine Engine Oil 1
Full
ENOW00940-0
4
During the break-in period, never run the
engine continuously at high speed.
e to
After running-in is completed, select the
correct propeller so that the engine
speed is the recommended range at the
wide-opon throttle.
After completing 5 hours of breakin,
replace the gear oil with new oil. Refer to
"Changing the gear oil" in subsection (2),
Periodic Inspection.
ENON00008-2
Note
During Break-in, run the outboard
motor at varied RPM less than specified
engine speed. Not following the proce-
dure may result in problems and may
shorten the product life.
Break-in must be conducted under
load in the water in-gear with propeller
installed.
CAUTION