Break-In - TOHATSU M 2.5A 2 Owner's Manual

assembly may cause a fuel leak, possibly
leading to fire or explosion.
Dispose aged or contaminated gasoline in
accordance with local regulations.
ENOW00029-1
WARNING
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out if the fuel tank cap is opened
by using another procedure when internal
pressure of fuel tank is raised by heat from
sources such as sun light.
1. Before opening fuel tank cap, turn air
vent screw two turns counterclock-
wise to release air pressure in the fuel
tank.
1
1. Two turns the air vent screw
2. Fuel tank cap
2. Open the fuel tank cap slowly.
3. Fill the fuel not to over the shown
level.
1. Full line
4. After filling the tank, close the tank
cap.
ENOM00033-B

4. Break-In

Your new outboard motor and lower unit
require break-in for the moving compo-
nents a ccording to the conditions
2
described in the following timetable.
ENOW00024-1
ENOF02007-0
Do not operate the outboard motor in
closed area or area with not enough ventila-
tion.
Exhaust gas emitted by the outboard motor
contains carbon monoxide that may cause
dizziness, nausea, other health problem or
even death if inhaled continuously.
During operation of the outboard motor:
Keep peripheral area well ventilated.
Always stay on the windward side of emis-
sion.
PRE-OPERATING PREPARATIONS
DANGER
23
1
ENOF02008-0
6