TOHATSU M 2.5A 2 Owner's Manual page 42

42
INSPECTION AND MAINTENANCE
ENOM00083-0
Washing outboard motor
ENOW00081-1
Do not start engine without removing pro-
peller, turning propeller out in the open may
lead to personal injury.
ENOW00082-0
Never start or operate the engine indoors or
in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be fatal
if inhaled for any length of time.
ENOW00920-0
When washing the outboard motor, be care-
ful not to spray the water inside of the top
cowl, especially electrical components.
ENON00026-0
Note
It is recommended to check chemical
properties of water on which your out-
board motor is regularly used.
10
If outboard motor is used in salt water,
brackish water or water with high acidic
level, use fresh water to remove salt,
chemicals or mud from exterior and
cooling water passage after every use or
before storing outboard motor for long
time. Before flushing, remove the propel-
ler and the forward thrust holder.
WARNING
WARNING
CAUTION
ENOM00085-B
Flushing attachment (3.5B2 only)
1. Tilt down the outboard motor.
2. Remove the water plug from the drive
shaft housing, and screw in the flush-
ing attachment.
3. Attach the flushing attachment and
connect a water hose. Turn on the
water and adjust the flow. Continue
flushing the outboard motor for 3 to 5
minutes.
4. After the flushing, be sure to reattach
the water plug.
1
1. Flushing attachment (option)
1
ENOF02040-0