Table of Contents
Advertisement
Hold gun firmly against side of container to
ground container and prevent static sparks.
Follow the material and solvent manufacturer's
warnings and instructions.
Use extreme caution when using materials with a
flashpoint below 70° F (21° C). Flashpoint is the
temperature that a fluid can produce enough
vapor to ignite.
Plastic can cause static sparks. Never hang
plastic to enclose a spray area. Do not use plastic
drop cloths when spraying flammable materials.
Use lowest possible pressure to flush equipment
WARNING
!
HAZARD: EXPLOSION HAZARD DUE TO
INCOMPATIBLE MATERIALS – will cause
severe injury or property damage.
PREVENTION:
Do not use materials containing bleach or
chlorine.
Do not use halogenated hydrocarbon solvents
such as bleach, mildewcide, methylene, chloride
and 1,1,1 – trichloroethane. They are not
compatible with aluminum.
Contact your coating supplier about the
compatibility of material with aluminum.
WARNING
!
HAZARD: HAZARDOUS VAPORS – Paints,
solvents, insecticides, and other materials
can be harmful if inhaled or come in contact
with the body. Vapors can cause severe
nausea, fainting, or poisoning.
PREVENTION:
Use a respirator or mask if vapors can be
inhaled. Read all instructions supplied with the
mask to be sure it will provide the necessary
protection.
Wear protective eyewear.
Wear protective clothing as required by coating
manufacturer.
77-2950-R7 (6/2023)
BINKS AIRLESS 75 SPRAY GUN
7 / 16
WARNING
!
HAZARD: GENERAL – Can cause severe
injury or property damage.
PREVENTION:
Read all instructions and safety precautions
before operating equipment.
Always disconnect the motor from the power
supply before working on the equipment.
Follow all appropriate local, state and national
codes governing ventilation, fire prevention, and
operation.
The United States Government Safety Standards
have been adopted under the Occupational
Safety and Health Act (OSHA). These standards,
particularly part 1926 of the Construction
Standards should be consulted.
Use only manufacturer authorized parts. User
assumes all risks and liabilities when using parts
that do not meet the minimum specifications and
safety devices of the pump manufacturer.
Before each use, check all hoses for cuts, leaks,
abrasion, or bulging of cover. Check for damage
or movement of couplings. Immediately replace
the hose if any of these conditions exist. Never
repair a paint hose. Replace it with another
grounded high-pressure hose.
All hoses, swivels, guns, and accessories must be
pressure rated at or above the maximum
operating pressure range of the airless sprayer.
Do not spray outdoors on windy days.
Wear protective clothing to keep paint off skin
and hair.
EN
www.carlisleft.com
Advertisement
Table of Contents
