Operation; Removing Jammed Staples - Parkside PDT 40 H6 Translation Of The Original Instructions

Operation

♦ Load the magazine
and staple gun as described in the section
"Filling the magazine".
♦ Set the correct working pressure using the
pressure reducer (not supplied).
NOTE
■ Make sure that you do not exceed the maxi-
mum working pressure of 8 bar on the tool.
Excessive working pressure does not mean
increased output; it merely increases the
compressed air consumption and accelerates
tool wear.
♦ Switch on the compressor.
Run the compressor once until the maximum
tank pressure has been reached and then
switch off the tool.
♦ Place the tool on the workpiece and pull the
trigger .
NOTE
■ The pneumatic nail and staple gun
is equipped with a safety yoke
The fastener material does not leave
the tool until the opening
nail and staple gun is pressed against the
workpiece and the trigger
■ Check whether the fastener is properly driven
in according to requirements.
–
If the fastener protrudes, increase the air
pressure in increments of 0.5 bar.
–
If the fastener is too deep, reduce the air
pressure in increments of 0.5 bar.
■ Alternatively, you can speed up the work by
holding the trigger
♦ Place the pneumatic nail and staple gun onto
the workpiece.
♦ Press the tool onto the workpiece till the
opening is touching it. The fastener material
exits the tool.
■ 8 │ GB │ IE
of the pneumatic nail
of the pneumatic
is pressed.
.
♦ As long as you pull the trigger
fastener material leaves the tool each time the
opening
■ Alternatively, you can keep the opening
of the tool permanently pressed onto the work-
piece.
♦ Each time you pull the trigger
exits the tool.
NOTE
■ Fine adjustment is also possible with the
knurled screw
♦ Turn the knurled screw
fastener deeper into the workpiece.
♦ Turn the knurled screw
less deeply into the workpiece.
♦ Turn the exhaust cover
air in the desired direction.
♦ Disconnect the tool from the compressor after
completing your work.

Removing jammed staples

If a staple/nail gets stuck in the magazine shaft,
.
immediately remove the compressed air supply
line.
♦ Open the magazine
section "Filling the magazine".
♦ Open the face plate
plate quick-release lever
the safety yoke
♦ Remove the jammed fastener.
♦ Close the face plate
plate quick-release lever
the exhaust cover
♦ Close the magazine
and staple gun as described in the section
"Filling the magazine".
, a piece of
touches the workpiece.
, a fastener
.
down to sink the
up to sink the fastener
to direct the escaping
as described in the
by pulling the face
in the direction of
.
by pulling the face
in the direction of
.
of the pneumatic nail
PDT 40 H6