How To Power Up The System; Figure 2-4 Power Up The System; Figure 2-5 Console Screen - MEDIATEK Genio 1200 User Manual

Genio 1200 EVK
Genio 1200 Evaluation Kit User Guide
2.8

How to Power Up the System

Power on the Genio 1200 EVK board by following steps.
Step1: Must install camera daughter board (DTB) on CAM0 or CAM2 connector.
(If camera app without in Android desktop, please refer to chapter 7 Appendix of Genio 1200 EVK User Guide for fixed it)
Step2: Connect UART0 to the computer via a micro-USB cable (If you want to see the logs).
Step3: Plug in the DC 12V power adapter.
Step4: Long press PWR button more than 3 seconds.
You will see the screen is shown on MIPI DSI display and some trace logs come out from UART0.

Figure 2-4 Power Up the System

Figure 2-5 Console Screen

Note: If you want to use the camera APP, please make sure to plug in the D2/D6 camera daughter board before power up
the EVK.
13
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.