How To Switch Boot From Emmc To Ufs; Figure 2-9 Boot On Strapping Path; Figure 2-10 Flash Tool Format Screen; Table 2-3 Boot Initiation (Sw5) - MEDIATEK Genio 1200 User Manual

2.10

How to Switch Boot from eMMC to UFS

You can choose to boot from eMMC or boot from UFS by switching the state of SW5.
Boot from eMMC
1: ON, 2: OFF (Default)
AUD_SYNC_MOSI
L
L
1. Power off the EVK, then switch DIP (SW5) to eMMC boot: Run "SP Flash Tool", on <Format> tab, press <Start> button
to format eMMC. Then plug the USB Type-C cable to EVK. It will format eMMC partition automatically.
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.

Table 2-3 Boot Initiation (SW5)

Table 2-4 SW5 Pin Status

AUD_CLK_MOSE
H (by external PU)
L

Figure 2-9 Boot on Strapping Path

Figure 2-10 Flash Tool Format Screen

Boot from UFS
1: OFF, 2: ON
Storage Booting
Only eMMC boot
Only UFS boot
Genio 1200 EVK
Genio 1200 Evaluation Kit User Guide
SW5
1: ON, 2: OFF (Default)
1: OFF, 2: ON
16