Antenna Connector; Pin Mux For Other Interface; Figure 3-3 Antenna Connectors; Table 3-13 On-Board Antenna - MEDIATEK Genio 1200 User Manual

3.15

Antenna Connector

Genio 1200 EVK has three Wi-Fi antenna connectors, users can connect them via coaxial cables. These antennas are
designed for AzueWave M.2 (MT7921) Wi-Fi module.
Wi-Fi ANT 2
Wi-Fi ANT 3
(Spare)
Location
J21
J23
J25
3.16

Pin Mux for Other Interface

J43 jumper default set to not support Raspberry Pi configuration. Use the J43 jumper to switch the GPIO shared by the M.2
slot (for MT7663), DSI, UART and Raspberry Pi Like I/O.
NOT Raspberry Pi Configuration
J43 short（default）
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.
AUX
MAIN

Figure 3-3 Antenna Connectors

Table 3-13 On-Board Antenna

Band
Antenna 1
Antenna 2
Antenna 3

Table 3-14 Other Interface (J43)

Genio 1200 Evaluation Kit User Guide
Wi-Fi/ BT ANT 1
Note
Wi-Fi / BT (AUX)
Wi-Fi (MAIN)
Spare
Raspberry Pi Configuration Supports
J43 open
Genio 1200 EVK
28