6
How to Power Up the Genio 700 EVK
1.
You must install the Camera DTB on the Genio 700 EVK board.
2. Connect UART0 (CN3200) to the computer via an USB cable. (If you want to see the logs.)
3. Power on the system by long pressing Power Key for 4 seconds or Plug a Jumper at J3001 and Auto power on by plug
in of AC adaptor.
4. You will see the boot-up picture on LCD display and trace logs come out from UART0.
After the EVK power on, pay attention to the LED indicator is lighted on.
In normal conditions, there are total 2 LED indicators that will light
Please refer to the marks of above Figure1-2
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.
Figure 6-1. Plug AC Adapter , Press Power Key and LEDs Status
Genio 700 EVK
Genio 700EVK Quick Start Guide
9