Installation
3.2
Quick Setup
Table 3-1 gives a quick overview of the CL-810 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
If installing a CL-810 Ultra/CineWide with AutoScope:
2
Install AutoScope lens motor (optional)
Mount the projector
3
If installing with an SDC-1, connect ONLY the SDC-1
output to the CL-810 and make all other connections to the
SDC-1; continue with Step 7
4
-- OR --
If installing without an SDC-1, connect signal sources to
the CL-810 and continue with Step 5
Connect external controller to RS-232 port (optional)
5
Connect 12-volt trigger output to AutoScope lens motor or
6
other equipment (optional)
Apply power to the projector
7
Change the OSD Language (optional)
8
For rear-screen and/or ceiling-mount installations, select
9
the proper picture orientation
Primary lens adjustments: projected image size (zoom),
10
position (shift) and focus
Install CineWide anamorphic lens (optional)
11
CineWide lens adjustments: position, pitch (angle),
12
geometry and focus
Projector calibration: adjust the following for each input;
save settings when finished:
• Aspect ratio
• Brightness
13
• Contrast
• Color level
• Tint
• Input position
Procedure
14
Runco CL-810 Series Owner's Operating Manual
For Details, Refer to
page...
15
22
25
27
30
31
32
33
33
18, 33
34
36
53 through 59