Installation
3.6
Connections to the
CL-810
Connector Panel Access
Connecting the SDC-1
System Expansion Device
to the CL-810
Proceed as follows to connect the CL-810 to your video sources, external controller(s) -- if
present -- and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
➤
To access the connector panel, pull
firmly on the cable access cover to
open it.
➤
If (and ONLY if) your installation includes an SDC-1 System Expansion Device:
Use a Runco R-Link cable to connect the SDC-1 output to the CL-810 R-Link input; see
Figure 3-9.
All signal sources should then be connected to the appropriate inputs on the rear panel of
the SDC-1. The signal from the SDC-1 is then output to the CL-810 projector via the
R-Link cable. For detailed instructions, refer to the SDC-1 Owner's Operating Manual.
Note
R-LINK IN
(from SDC-1 Controller
R-Link Output to Projector
R-Link Input)
INPUT FROM SDC-1
SDC-1
Runco International
Union City, CA
BOTH OUTPUTS MUST BE
CONNECTED TO PROJECTOR
SDC-1
SYSTEM EXPANSION DEVICE
OUTPUTS TO
PROJECTOR
Figure 3-9. Connecting the CL-810 to the SDC-1
Connect ONLY an SDC-1 to the R-Link input! Although the
R-Link looks like a DVI input, it does not function like one and
cannot be used as an additional video input.
FROM
INPUT
CL-810 Connector Panel
Serial No
V
H
HDMI / DVI
2
1
V
H
DIGITAL
INPUTS
SDC-1 Rear Panel
26
S-VID
S-VID /
HD-1 INPUTS
VIDEO
T
B
G
R
B
G
R
S-VIDEO
HD-2 INPUTS
Runco CL-810 Series Owner's Operating Manual