Isf Calibration - Runco Reflection CL-810 CineWide Owner's Operating Manual

Operation

ISF Calibration

ISF Calibration
Reset Picture Adjust
Picture Adjust
White Balance
Gamma Selection
Blue Image
ICC Adjust
Store Settings
Splash Screen Timer
ISF Enable
Return to User OSD
➤
To access the ISF Calibration menu, select ISF Calibration from the Main Menu and press
ENTER. Use the number buttons on the remote control to enter the ISF Calibration menu
passcode when prompted and press ENTER again. Then, press MENU on the remote
control.
Note
Reset Picture Adjust: To restore the ISF default image settings for the current input
source ONLY, press the
Picture Adjust: These settings are described in the Picture Adjustment section
(page 48).
White Balance / Gamma Selection: These settings are described in the previous
section, Set Up.
Blue Image: This setting is described in the Installation section (refer to page 56).
ICC Adjust: Use the ICC Adjust controls to customize the stored NTSC, HDTV and/or
PAL color space characteristics. To do this, select the color space to modify. Then, select
a component color (Red, Green, Blue, Yellow, Cyan or Magenta).
For each component color, you can adjust the following:
• Intensity: This slidebar adjusts the intensity -- also known as luminance -- of a given
color.
• Sat. This slidebar adjusts the color saturation level -- the amount of that color in a video
image. Lower settings produce less saturated colors; a setting of "0" removes that
color from the image entirely. If the saturation is too high, that color will be
overpowering and unrealistic.
• Hue: This slidebar adjusts the red/green color hue for true color reproduction of video
signals. For best results, adjust tint while displaying an external color bars test pattern
(see Figure 4-4). Otherwise, it is recommended that Hue remain at its default setting.
When you have finished customizing the color space, select Store Setting and press
ENTER.
Store Settings: For each input, the CL-810 lets you store image quality settings as
presets that you can recall at a later time. You can create up to three presets per input
and resolution.
Note
When you have finished calibration, select Store Settings and choose "Memory 1," "ISF
Night" or "ISF Day" to store your settings.
To recall stored custom image quality settings, select Restore Image Settings from the
Adjustment menu (refer to Picture Adjustment on page 48) and choose "Memory 1,"
"ISF Night" or "ISF Day." Or, simply use the corresponding buttons on the remote control.
This menu should be used by ISF-certified technicians only.
button to highlight "Yes" then press ENTER.
When you change a setting, save the change to a preset
afterwards. Otherwise, the change will be lost when a different
input is selected. (Most settings are saved for each input and
resolution separately.)
62 Runco CL-810 Series Owner's Operating Manual