Connecting To Ac Power; Turning On The Power - Runco Reflection CL-810 CineWide Owner's Operating Manual

Installation

Connecting to AC Power

3.7

Turning on the Power

➤
Projector: The CL-810 ships with
various types of AC power cords.
Choose the one that is appropriate
to your locale.
Plug the female end of the power
cord into the AC receptacle on the
rear of the projector (AC 100V ~
240V). Then, connect the other end
to your AC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
Caution
AutoScope Lens Motor (Rear)
Power
AC Input
Switch
1. Turn on your source components.
2. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input (see above).
3. Turn on the main power switch at the rear of the projector. The POWER LED lights
orange. The LAMP and TEMP LEDs light red briefly, then go out.
4. Press the ON button on the remote control to turn on the CL-810. The POWER LED
flashes orange to indicate that it is warming up.
5. When the projector is ready for use, the POWER LED lights green.
6. "Searching..." appears on the screen before the CL-810 identifies the input signal and
remains there until a valid signal is detected.
7. If an incompatible input signal exceeds the range of the projector, a "No signal
supported" message appears on the screen. This message remains on the screen
until you change the input signal.
The input voltage to the AutoScope lens motor must be between
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240 VAC power source!
32 Runco CL-810 Series Owner's Operating Manual
Power
switch
to
110 VAC
Power