CARDIOSTRONG CST-TR20-3 Assembly And Operating Instructions Manual page 34

N/A The LED on the start button glows faintly, other LEDs are not on: The machine is in power
saving mode. Hold the START button for one second.
N/A The console display is fluctuating or does not light up: Check if the treadmill is correctly
connected to the power supply. Turn the power switch off and back on. Safety key is plug-
ged in. Check all cable connections for correct connection. If the problem is still occurring,
please contact customer service.
N/A The belt does not run in the middle during usage:
First check if the treadmill has a stable position, then follow the operating manual in regards
to tension and adjusting the belt (the deck).
N/A The motor appears to be overloaded or E1 appears after a few minutes of training:
The silicone applied to the deck and belt has dried out and the deck must be lubricated
again with silicone spray.
N/A The running mat slips during usage. The belt must be tensioned after a certain amount
of usage. Follow the belt tensioning and alignment in this manual.
N/A Heart rate fluctuates or is not recorded:
Check to see if your hands are moist, if all connections behind the console are correct and if
any cables are damaged. With a chest strap, check the battery status and make sure that all
electrodes are moist and correctly placed below the chest.
N/A Silicone symbol is illuminated on the console:
Lubricate the machine with 100% pure silicone. Then press speed down and START at the
same time until the symbol goes out.
34
TR20