Compressor Assembly; Storage And Transportation; Setting Up - Danfoss BOCK UL-HGX24e CO2 LT Operating Manual

4 | Compressor assembly

4.1 Storage and transportation

?

4.2 Setting up

D
US
3
10 | AQ450435396289en-US0201
New compressors are factory-filled with inert gas. Leave this
service charge in the compressor for as long as possible and pre-
vent the ingress of air. Check the compressor for transport damage
before starting any work.
Storage at -22°F ... 158°F (-30 °C) - (+70 °C), maximum permissible
relative humidity 10 % - 95 %, no condensation.
Do not store in a corrosive, dusty, vaporous atmosphere or in a com-
bustible environment.
Use transport eyelet.
Do not lift manually!
Use lifting gear!
Attachments (e.g. pipe holders, additional units, fastening parts,
etc.) directly to the compressor are not permissible!
2 1
Provide adequate clearance for maintenance work.
Ensure adequate compressor ventilation.
Do not use in a corrosive, dusty, damp atmosphere or a com-
bustible environment.
Setup on an even surface or frame with sufficient load-bearing
capacity.
Single compressor preferably on vibration damper.
Compound connection basically rigid.
F
E
D
© Danfoss | Climate Solutions | 2023.07
C